To remove a wire from a reusable push-in connector, simply hold the connector in one hand and, using a slight twisting motion, pull the wire away from the connector with your other hand. Additionally, the clear shell makes it easier to spot a loose connection during repairs, and because of its small size, they fit easily within junction boxes. Push-in connectors have a clear shell allowing you to see if the connection was made tightly. Be sure the wire is inserted deep enough into the connector so that if you give it a good tug it won't easily come back out. Now simply push the stripped wire into one of the ports (these connectors are available with anywhere from 2 to 4 ports depending on your wiring requirements). Start by using a wire stripper or crimper to remove about ½" of the wire's insulation. As the name suggests, the connection is made by pushing the solid wire into the connector until it sits tightly in place. These connectors are for use with solid wire only, as stranded wire will not connect securely in the ports of the connector. Twist-on connectors, however, aren't typically used on wiring thicker than AWG #10, as solid wire like this is too stiff to be used with this type of connector. Easy to twist on and off if necessary, they're often used in electrical wiring systems for light switches, ceiling fans, electrical receptacles or outlets, security systems, HVAC, and more. Twist-on connectors are commonly color-coded to indicate the size or capacity of the connector. If you need to remove the connector, simply twist it counter-clockwise until it comes loose. A wire nut is a device that aids in the connection of a group of electrical. They are held in place by interior grooves or a tapered coiled metal spring inside the connector, which threads onto the joined wires to hold them tightly together. Any DIY home handyman who as undertaken any electrical work has used wire nuts. Align side-by-side and twist together the stripped area of the wires, slide the connecter over the two wires, and twist it clockwise to make the connection. To use, strip the two wires to be connected about ½" from the end. These are available with external grooves or with wings for easy handling and are typically twisted on by hand.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |